Online shopping

Considerations

• Deposition of dust and grease on the build plate decrease adhesion. It is recommended to regularly clean the surface with detergent and water to to maintain best adhesion.

• Increasing heatbed temperature enhances adhesion. Users need to adjust the temperature of the heatbed based on their specific requirements in order to achieve the most suitable level of adhesion.

• Carefully sanding the Textured PEI surface with fine-grit (600 was recommended) sandpaper can help restore adhesion.

• If bubbles appear on the bottom of the Smooth PEI sheet, heating it on the heatbed at a temperature of no less than 80 degrees for several hours can be helpful in eliminating the bubbles.

• Do not clean the Bambu Dual-Texture PEI Plate with Acetone, as it will damage the PEI surface.

• Bambu Lab recommends only using Bambu Lab official glue on the Bambu Lab build plates, and can not be held responsible for any damage caused to plates as a result of using third-party glue on build plates. 

• Always wait for a few minutes before removing printed models to allow the plate to cool down for easy print removal. This prevents damage to the plate and ensures a long lifetime of the product.

• The Bambu Dual-Texture PEI Plate is considered a consumable part, which will degrade over time.

Recommended Settings

Please note that other slicer settings might need to be adjusted based on the printed model and the filament requirements

Installation Steps

Step 1: Align the plate with the fixed points of the platform with the name of the plate facing you




Step 2 : Lower the plate and secure to the magnetic platforma